Send an inquiry

Waterproof flat disc thermostat

Waterproof thermostat, can be incorporated inside thin heating devices, heating blankets, heating pads, antifreeze cables, electrical floor heating

Dimensions 36.6 × 22 × 5.7 mm
Electrical rating

Opening temperature (°C)

, , ,

Closing temperature (°C)

, , ,

Wire lengths (mm)

,

SKU: N/A Category: Tags: , , ,

TECHNICAL FEATURES

Application: Waterproof thermostat, can be incorporated inside thin heating devices, heating blankets, heating pads, antifreeze cables, electrical floor heating

Electrical rating: 8A,125VAC res 4A, 250VAC res

Temperature calibration range: 0 to 120°C (32 to 248°F)

Contact: open or close on temperature rise

Differential: 8-15°C (46.4-59°F)

Tolerance: ±5°C on open and close

Contact resistance: < 70 mΩ (wires and optional TCO not included)

Insulation resistance: ≥ 100MΩ @500VDC

Thermal resistance: -20°C +130°C (except optional thermal fuse and wires)

Electrical life: ≥10.000 cycles under rated load

Wires: PVC insulated, 0.5 mm² (0.75 mm² on request), length 100, 200, 500, 1000 mm

Option: built-in thermal fuse, 2A, 5A or 8A.

Thermal fuse calibration must be at least 30°C higher than thermostat opening temperature (MOQ apply)

 

Main references

Downloads

Datasheet

Related products

Quick View

Disc thermostats

Snap action disc thermostat, reduced height

Quick View

Bimetal surface thermostats

Room humidistat and thermostat combination, wall mounting, for swimming pools areas and air conditioning

Quick View

Bimetal rod thermostats

SPDT Bimetal rod thermostats with dead zone

Quick View

Bimetal surface thermostats

Dia. 10mm cartridge thermostat 1/2″BSPT or M14x1.5 fitting, calibration from 50 to 120°C

Quick View

Disc thermostats

Snap action bimetal disc thermostat, ½” disc. 12 mm thickness, 16A 250V Type 4903

Quick View

Bimetal rod thermostats

Rod thermostats, DPST and SPDT

Technical informations associated to this product

  • Description of temperature controls

    Used as control thermostats or as a safety thermostat with manual reset, these thermostats have a disc made of two different metals laminated together for temperature sensing element. These two metals have different expansion coefficients.

  • Thermostats installation

    The proper functioning of a thermostat depends primarily on the correct choice of the component, but also the conditions of its installation. Conditions used to calibrate regulating and control equipment in the factory are always ideal laboratory conditions, ensuring measurement accuracy and repeatability. These conditions are rarely those found in practice when installing thermostats. However, with a minimum of constraints, it is possible to optimize assemblies.

  • Electrical protection classes

    The housings are designed to protect electrical equipment located inside. This protection must be considered in the electrical and environmental angles.)

  • Electrical contacts

    As numerous mechanisms exist, we decided not to distinguish on the basis of constructive technique, but according to their operation speed, which is the key element.